EBPV Swap
#1
EBPV Swap
After pulling my valley apart to find an oil leak, I determined that it was the EBVP pedestal that was leaking. I ordered a non-EBVP pedestal and high flow outlet, along with a 4" downpipe (and new Viton o-rings from Guzzle's). What do I do with the wire from the original EBVP? Can I run it to the source and snip it or what? Less wires in the valley makes for an easier oil cleanup (if it decides to stop leaking....***knock on wood***).
#3
Thread
Thread Starter
Forum
Replies
Last Post