EBPV Swap
 

After pulling my valley apart to find an oil leak, I determined that it was the EBVP pedestal that was leaking. I ordered a non-EBVP pedestal and high flow outlet, along with a 4" downpipe (and new Viton o-rings from Guzzle's). What do I do with the wire from the original EBVP? Can I run it to the source and snip it or what? Less wires in the valley makes for an easier oil cleanup (if it decides to stop leaking....***knock on wood***).:humm:

i'd just put a rubber cap on it and tape it to the est of the harness.

let me know if you notice any differance with that mod, im thinkn about doing same thing. i already have the down pipe but mine starting to leak too and i figured while i was in there i mite as well upgrade.

i don't think it adds anything or takes anything away. it just gets rid of a possible oil leak.