EBPV not closing,,,
#11
I mean i inhooked the pcm from the EBPV and wired it to a toggle switch, like everyone says i could, and when i sent power to the EBPV it would close, this way i had control over the EBPV,
---AutoMerged DoublePost---
does anybody know where i can buy a new EBPV ive searched ebay and also googled it and i cant find a thing!! any help guys??
---AutoMerged DoublePost---
does anybody know where i can buy a new EBPV ive searched ebay and also googled it and i cant find a thing!! any help guys??
Last edited by 99stackedpowerstroke; 12-22-2010 at 03:01 PM. Reason: Automerged Doublepost
#13
#14
Disconnect the rod from the EBPV. It's the one under the turbine housing.
See if you can freely move the valve by hand while the engine is running. See if the exhaust tone changes. If that part works, you either have an internal leak in the actuator or you have an open circuit in the solenoid itself. Do a resistance check on the solenoid.
See if you can freely move the valve by hand while the engine is running. See if the exhaust tone changes. If that part works, you either have an internal leak in the actuator or you have an open circuit in the solenoid itself. Do a resistance check on the solenoid.
#15
Thread
Thread Starter
Forum
Replies
Last Post