that bolts into the pcm, so unless hes ever taken the pcm out then there shouldnt be any worry about it.

 

Just saying one of the post here a few months ago talked about corroson at this connector,even though it is sealed by a rubber gasket it could get moisture in it.Not arguing

 

not arguin bud just sayin the likely hood of it being that is pretty slim.. id say that if someone did get corrosion in the connector they were playing around in too much mud/water...

 

 

This sucks ok new 8 inj it passed the buzz test but not the contributed test still runs bad what could it be if it passed buzz but not other think bad. Inj

---AutoMerged DoublePost---

Still lost

 

Help guys

 

Have you checked the UVC harness?

 

YEAH THERE GOOD now the trans temp is 250 I think I'm done with this truck and ideas on why the trans is up

 

... You need to take it to someone...

 

I am new to the site and haveing a little problem were to post at.I hope this is the correct place. I am also having a problem with my 7.3. It stumbles and smokes and has no power when it is doing this. i have changed filter,harness under the valve cover and valve cover gaskets. It had new injectors and glow plugs about 15000 miles ago. It will run ok (sort of) and then start smoking and loses power. The smoke is white or light gray and smells like diesel. I had the codes checked and there was none. Any help will be greatly appreciated.

This is a great site !