To bore or sleeve?????
#1
To bore or sleeve?????
I am wanting to rebuild my '96 without spending the trucks blue-book on a reman. One machinist said I had to sleeve the cylinders back to stock because of known porosity in the blocks that cause cylinder failure if bored even a little. However, I just read in Desiel Power where they built a .030 over motor, although it was a '99 or newer model. Looking for educated opinions out there, Thanks
#2
#3
Thread
Thread Starter
Forum
Replies
Last Post
yfzrunner
12 Valve 2nd Gen Dodge Cummins 94-98
1
09-17-2015 05:23 AM
CumminsCoalRoller24/7
5.9 Liter CR Dodge Cummins 03-07
4
01-29-2015 08:37 AM