Clutch Question
#1
Clutch Question
I have the 97 F350, and the pin that is on the cluth linkage that connects the push rod for the Master Cylinder is worn halfway through. I have been searching and cannot find any place to get a new pin or even this small piece of linkage (if it comes to that). I will not call my Ford Dealer as I have had bad luck with them in the past. Any help is appreciated.
#3
#4
#5
Ok, I go the linkage replaced along with the master cylinder, but bent the line. Does anyone know how the line disconnects from the lower end by the transmission? I can see the fitting on the lower end but cannot see a pin like there is at the top to remove, so am looking for any help in getting this line off. The part store lists two different lines for this truck so I need to remove this one and take it down as there is a $50 price difference between the two.
Thread
Thread Starter
Forum
Replies
Last Post
Turbo67
Dodge Truck and Cummins Turbo Diesel Forum
0
07-25-2015 02:26 PM