need advice
#1
need advice
Hi i just bought a 97 f350 mason dump and noticed that the exaust was leaking from both sides from the doughnut gaskets.So i usually do all my own work but havent had time so i took it to a garage for an estimate and they told me the manifolds are so flacky there both leaking and need to be replaced and there could be a chance the block is rotted,also they said they had to pull the motor to change the manifolds,wow,so my first ford 3rd diesel what do you guys think.i can get at the manifolds thru the wheel wells correct thx
#2
ahhh. . .no. I wouldn't be trusting that.
I'd put the exhaust seals on first. if it leaks after that, then I'd look into it if I still heard or knew of a big exhaust leak.
Rather than pull the motor, if you have access to a 2 post hoist, pull the cab. Can be done quicker than pulling the motor in many cases, and gives you all the room in the world.
I'd put the exhaust seals on first. if it leaks after that, then I'd look into it if I still heard or knew of a big exhaust leak.
Rather than pull the motor, if you have access to a 2 post hoist, pull the cab. Can be done quicker than pulling the motor in many cases, and gives you all the room in the world.
#3
#4
Thread
Thread Starter
Forum
Replies
Last Post
Spaky6.0mudder
Ford Powerstroke 03-07 6.0L
7
08-03-2015 08:54 PM
jrsavoie
Chevy/GMC 6.2L and 6.5L
1
02-06-2015 09:44 PM