'93 F350 IDI- about to turbo - advice
#1
'93 F350 IDI- about to turbo - advice
say Mates :
new guy here to this board . am about to turbo the 7.3 idi - just refreshed heads and gaskets - New ip....gave a fresh paint job to most of the parts I removed - any advice before I put moteur back into cradle ? going with a used ATS system / full size down pipe and will look to set up gauges
cheers in advance
new guy here to this board . am about to turbo the 7.3 idi - just refreshed heads and gaskets - New ip....gave a fresh paint job to most of the parts I removed - any advice before I put moteur back into cradle ? going with a used ATS system / full size down pipe and will look to set up gauges
cheers in advance
#2
just bolt it on and go. after putting the turbo on u wil want to turn the pump up about 2 flats to get full usage of the boost.
and unless the cab is off, u will need to set motor in first, then put the turbo on. it is a tight fit back there. before putting the motor in, take a BFH and beat the pinch weld on the cab over to give you more clearance.
and unless the cab is off, u will need to set motor in first, then put the turbo on. it is a tight fit back there. before putting the motor in, take a BFH and beat the pinch weld on the cab over to give you more clearance.
Thread
Thread Starter
Forum
Replies
Last Post
schearer350
Ford 83-94 6.9 and 7.3L General
2
02-12-2015 12:27 AM
jrsavoie
Chevy/GMC 6.2L and 6.5L
1
02-06-2015 09:44 PM
g.logistics
Ford 83-94 6.9 and 7.3L General
9
11-22-2014 08:54 AM