Not very much, just got it. I put 6 Alcoa rims and new tires and all fluids. Rear is next when I can get back to it......

 

I'm looking for a nice set of wheel for my truck, the original ones do not do it justice

 

I was lucky I found 6 Alcoa aluminum for 500.00 all I have a quite a few steel ones
Some have decent rubber......

 

Any ideas what to look for? It's pretty bare out here in Arizona. At least in my part of the valley it is

---AutoMerged DoublePost---

The 8x165 won't fit these older trucks will they

---AutoMerged DoublePost---

dumb question, just realized they are the same

 

I think the Bolt pattern is the same. Cause my barge is 16.6 and they fit my f350.

---AutoMerged DoublePost---

I mean 16.5

---AutoMerged DoublePost---

No worries. Them alcoa's are hard 2 find, unless u buy new

 

the wheels on my truck are for sale if someone wants them .. look at my pics .... $200.00 if interested PM me ....

 

I might take you up on the 4x4. Either that, or I'm gonna buy THESE

 

I need those tires just cuz they say big foot...tires on my bigfoot are older than me an dry rotted...still has perfect tread though

Sent from my SCH-I605 using Tapatalk

---AutoMerged DoublePost---

Have 3.55s in my rig but they were installed at the factory so Cnt tell ya anything accept she'll pull a 50 ft boat and run at 60mph@ 1.1k 70-80mph 2.1-2.3k up or downhill

Sent from my SCH-I605 using Tapatalk

 

Sounds like a pretty good range, currently with the 4.10s I don't go over 65mph cause it will have me at 2k+ , and I get my best mileage at 60mph with 1.8k

---AutoMerged DoublePost---

Those are some nice looking wheels though, found some nice looking Alcoas for 200 for the set, but they are for 8x170

 

Think my f150 came stock 31 10.5....15s. Do u know who makes that tire? Have an 87 bigfoot cruiser

Sent from my SCH-I605 using Tapatalk