6.9 oil cooler questions
#1
6.9 oil cooler questions
in the process of buying an 85 rclb 4x4 with 6.9 t-18 and 3.54 gears only paying 1400 bucks for it and the body is a solid 9/10 the problem is that oil is leaking into the coolant and i remember they guy sayig that either him or his friend (the previous owner before him) re o-ringed the oil cooler if the problem is the o-rings then its no issue to just o-ring it and go on but if it is say the core itself can i block off the oil cooler and run an external cooler up front using one of the plates that screws onto the oil filter threads
---AutoMerged DoublePost---
just realized that the oil filter screws on to the rear piece of the oil cooler but i could make two plates the have welded on fittings for both coolant and oil and have the oil run through a remote filter and then through this heat exchanger all for about 200 dollars less than the replacement core 26.4 GPM Return Line Heat Exchanger | Princess Auto
---AutoMerged DoublePost---
just realized that the oil filter screws on to the rear piece of the oil cooler but i could make two plates the have welded on fittings for both coolant and oil and have the oil run through a remote filter and then through this heat exchanger all for about 200 dollars less than the replacement core 26.4 GPM Return Line Heat Exchanger | Princess Auto
Last edited by strokedout6.9turbo; 03-04-2013 at 08:51 PM. Reason: Automerged Doublepost
#4
#5
Thread
Thread Starter
Forum
Replies
Last Post
Bighouse
Ford Powerstroke 03-07 6.0L
1
04-09-2015 06:51 PM