Okay so I have a ts 6 position chip so I figured I should have a lil more air flow and after installing my 6637 filter when I have my chip set on stalk it runs for 10 seconds then dies but if I have it set on +50 on up to +140 it runs and idles fine. Any ideas? Until then il keep it out of stalk

 

bad switch? improperly programmed chip?

 

No because it worked just fine before I put the new air filter would putting the MAFS back in the filter change anything?

 

what maf?

 

Mass air flow sensor

 

no MAF present on a 7.3

 

What ever you unhooked and removed with the stock intake has to be put back into the new one.

 

IDI does not use chips or maf..... these engines are mechanical and do not have a engine computer