Installed DIY cold air intake won't stay running
Okay so I have a ts 6 position chip so I figured I should have a lil more air flow and after installing my 6637 filter when I have my chip set on stalk it runs for 10 seconds then dies but if I have it set on +50 on up to +140 it runs and idles fine. Any ideas? Until then il keep it out of stalk
|
bad switch? improperly programmed chip?
|
No because it worked just fine before I put the new air filter would putting the MAFS back in the filter change anything?
|
what maf?
|
Mass air flow sensor
|
no MAF present on a 7.3
|
What ever you unhooked and removed with the stock intake has to be put back into the new one.
|
IDI does not use chips or maf..... these engines are mechanical and do not have a engine computer
|
All times are GMT -5. The time now is 05:53 AM. |
© 2024 MH Sub I, LLC dba Internet Brands