that looks sweet man!

 

Thanks!

 

Amber is pulling with it...


---AutoMerged DoublePost---

I'll take one of each Ian, those look sweet!!!

one thing I'm sure you've thought about but thought I'd bring up anyway...
On the driveshaft loop, make sure it fits tight enough it doesnt rattle going down the road with the quick pin design. Again, I'm sure you already thought of it, but could not stop myself!!!

If I could weld aluminum I would make my own rad. cover

 

Amber did make her first pass down the track with 271' at the New Era pull in Zanesville. I rode shotgun and it was stressful! but Im very proud of her, the truck did start to dig a bit at the end and she freaked out and let off the go pedal.

The loop doesnt make any noise. the pin is up high enough that there isnt much wiggle and I also put never-seize on it to keep it free.

Ian

 

Ian, you can consider your ideas as good as stolen, thanks bud.

 

haha hey no problem, I just altered the rad cover from others ive seen and the loop idea is just something quick and easy , works perfect and no holes have to be drilled

if ya need specs on either of them let me know

Ian