it is really easy once you get going on it I have my bracket made will get it on tomorrow am and will post picture

redneckvette--- how is your sonoma project coming if you do yours that would be great then there will be 3 of us on here doing the same swap

 

just ordered my adapter to the ax15 trans a few minutes ago from koch cant wait to get it. i go to the yard tommorow to get the 2wd jeep trans. the owner of the yard is a good friend of mine (i worked thewre for a while) so i worked a deal with him to trade my 2.2 and five speed for all the jeep stuff i need (trans, flywheel, clutch, slave cylinder, drive shaft, starter ect. painting the motor this weekend and valve cover gasket should be here tomorrow. all going well so far.

 

that sounds great we all love pictures post some

now on to mine slave cyl is mounted and ready to go now I can start on s10 stuff getting clutch in lifting body putting engine trans in for a test fit

 

I put my post on benzworld and the purists already dinged me I wish that that site was more like this one here

---AutoMerged DoublePost---

so I have my slave all installed but I am wondering should the rod for the slave cyl have just a little play or should it be tight in other words should the throw out bearing turn when the clutch is not depressed or should it turn

 

on every hydraulic clutch ive ever worked on the slave always kept some pressure on the rod to the clutch fork

 

Deck60 on the 95 s10 clutch it has the cylinder on the side of the trans and they are tight with a little press on them vette

 

thanks that is how it is set up

 

just pulled the trans and other needed items from my 2wd jeep 5sp donor vehicle. discovered that the reason that the truck was there is because of the clutch being shot. darn i was hoping it was good just to get me by for a while, luckaly autozone has one in stock ill pick it up tommorow when i go to get my valve cover gasket.have to go to my pool banquet right now ill post some picks of the progress tomorrow