Any of you willing to do a swap on my junk
I have an 87 GMC Suburban that needs a cummins powertrain. Any of you guys that have done these swaps want or know who and how much it is going to take to have this done?
alot of time and alot of money. other than that its not too bad
Mark:
I got your PM, but it wont let me send you one until my post counts up.
---AutoMerged DoublePost---
My question to you and to anyone; What would be a rough idea of how much this will cost from start to finish?
---AutoMerged DoublePost---
Now I know there's many ways to do this, but I am talking the way that will cost the least to get the burb just to where it will pull my 25 foot camp trailer and two wheeler on a small trailer up the canyon without heating up or breaking down.
---AutoMerged DoublePost---
After that, I can bomb proof it a little at a time.




---AutoMerged DoublePost---
Next question is; Those of you that put these cummins engines in, where do you get them? And those who do this on a very limited budget, what are some tips?
I got your PM, but it wont let me send you one until my post counts up.
---AutoMerged DoublePost---
My question to you and to anyone; What would be a rough idea of how much this will cost from start to finish?
---AutoMerged DoublePost---
Now I know there's many ways to do this, but I am talking the way that will cost the least to get the burb just to where it will pull my 25 foot camp trailer and two wheeler on a small trailer up the canyon without heating up or breaking down.
---AutoMerged DoublePost---
After that, I can bomb proof it a little at a time.





---AutoMerged DoublePost---
Next question is; Those of you that put these cummins engines in, where do you get them? And those who do this on a very limited budget, what are some tips?
Last edited by Moon; Sep 10, 2010 at 11:22 AM. Reason: Automerged Doublepost
buy a complete truck dont try piecing it together. and make sure everything runs and works good before buying it. but no matter what way you look at it it isnt a cheap conversion in general.
So then in your case, why even do it. If you are buying a complete truck anyway that runs and works good? Why not just drive that dodge you bought instead of putting it in a chevy, that doesn't have a solid front axle?


