Chevy body on a dodge frame
#13
rad support mounts are the only keepers, gonna chop and reweld the other 4. Had to cut the front most box perches off(chebby can is 10.5 inches longer)Kinda mocked the hydroboost, the 2 holes on the inside fit perfectly the outter ones i gotta poke holes in the firewall, what a pile of crap with the abs motor... Clutch master ill have to wing it.. Looks to be a stamp on the firewall where it would have a clutch master if it was a manual unit?. The nbs cab has a stamp on the floor for the shift tower, cut that out and had to trim a little extra, gonna have to run efans.. Hopefully low enough profile ones exist.. Then i will attempt to intergrate the bcm to the engine harness.
That was a good weekend
That was a good weekend
#15
Awwyeaaa! Got a hold of a 02 2500hd Big hood! Not that it needs it to be cool..but now its turned up to 11!!
Attachment 30873
Attachment 30873
Last edited by BentWrench; 05-10-2016 at 08:07 PM.
#19