ANYONE DONE A PERKINS CONVERSION?
#1
ANYONE DONE A PERKINS CONVERSION?
I've recently acquired a couple of 4 cyl Perkins diesels salvaged from 400 amp portable welders. One had a fresh rebuild shortly before the welder died but it's been sitting for a couple of years. Both turn freely and were full of oil and anti freeze when "parked". I know some early Rangers had perkins in them but has anyone heard of someone putting one in a full sized half ton like a Ford f-150? Would this be a worthwhile project?
#2
#3
there is a guy on Dodge Diesel - Diesel Truck Resource - Cummins - Home that put a 6cyl perkins into a 198* something ford 1 ton, he done a great job on it, worthwhile taking a look at
#4
Years ago I put a 6 cyl perkins out of a 510 massey combine in a ford econoline van.We built a adapter for the c-6 and a hub adapter for the crankshaft.After several trys to get it centered right it worked okay.The engine shook worse than a 4bt and was only in the 16 to 18 mpg gallon range,This was after a turbo and fuel tuning.I wasnt that impressed and it got out ran by a isuzu we put in a 3/4 ton ford pu with the same trans/gear combination
Thread
Thread Starter
Forum
Replies
Last Post
CGwill
24 Valve 2nd Gen Dodge Cummins 98.5-02
0
01-26-2015 02:10 AM
TyCarp
24 Valve 2nd Gen Dodge Cummins 98.5-02
0
12-10-2014 11:02 AM