What kinda conditions are the motors in? the best im seeing in Missouri is 1250 but their guaranteed to run for 90 days that's a v2203. Thank you, like I said I got another dealership out of California working on a motor source for me as well but they are super busy so its taking a while for him. Surplus center didn't show any motors when I checked today. Thanks for the help I appreciate it. Send me a picture of the counter shaft if you can, and also the tranny bell housing has to be notched for the starter to clear. we couldn't do anything about that.... but I bolt an extension cover for mine. Unfortunately the cost to make these plates went up on me... its gunna be $400 shipped. my apologies.... Were still trying to find a cheaper material source. id like to be able to make them for the $250 $300 range but I don't know if I will ever be able to. Like I said I have 2 plates. you can P.M. me your address. and if you can we will do the purchase through paypal. I will pay the fees for that as well. plates are being made right now

 

Hey Gaines12, My understanding on the engines is that they are not running but they are sold as rebuildable cores. You might try e-bay I hear there are a surplus of carrier refidgeration container kubota"s out there. I just called Travis (at the dealership) and invited him to join the thread so he can post the engines they have available. I would like to get my contact / shipping info to you along with my phone # as well as get your's so I can send you a picture of my M -SERIES V2203 from my phone. Also if you can invoice me with pay pal then I can go ahead and pay you and get the adapter on its way. Provided the counter shaft doesn't cause interferance. I don't know how to p.m. my info to you and actually don't know what p.m. stands for. DAA.. I thought you meant postal money order. So as soon as I get that figured out I'll go forward. Any coaching would be appreciated Thanks

 

PM stands for Private Message. Click on Gaines12 above where it says "Diesel Fan" on his post. A drop down menu should come up, then click on "Send a private message to Gaines12"

 

Heard anything from the dealership yet? do you know if your bolt pattern is the same as mine? and does that countershaft stick out past the back of the block? I think I might be able to just flip the starter to the other side..... I wish I could get ahold of one of those motors so I can make a plate for it too!

 

Hi Gaines, What thickness adapter plate did you end up with. If I read correctly are you using 1" aluminum plate

thanks

 

ya its a couple thousandth over one inch. Your flywheel gets machined to ensure proper input shaft depth with these plates. Heres a picture of the one getting sent to jestergrin tomorrow

 

Now those are some pictures. But I still can not figure out why your pictures are always sideways?

Gaines I will fix it. Here is a couple of pictures of Gaines Adapter.

 

Thank you for that sir! my phone takes bigger pictures sideways, that's why they are sideways haha but those look good! and a lot bigger too

 

No Problem. I am glad your voice mail works.

 

Ya me too I stay rather busy. especially sense I got back from Oklahoma its been hetic....