Eastern Aggie did you do any frame work on your truck?

 

Why ?

---AutoMerged DoublePost---

Dude, put that bitch in there and get some f 250 springs and call it a day

 

I did not. For stock and mildly modified power levels, and daily driving, the frame will hold up fine. If I was going to be doing more mods (tuning, injectors, turbo, and up), and launching at the track, I would box the frame. But over two years with mine and its just fine.

 

I still want to know why you don't want a bad *** engine in a half ton truck

 

well plan on 500-600 hp eventually as of now the motor is a ppumped 24v fass fuel 181/210 cam cai exhaust 4kgsk mack rack plug and .93 injector lines with drilled out crossover tubes

 

A set of injectors, a set of DV's, and a set of compounds should get you there. You might even get away with a big single since you have a cam. You've got a pretty good engine to start with.

 

ya plan on 7x.012 injectors 66mm turbo 3pc manifold some sdx comp delivery valves and a dd sb street clutch with input shaft upgrade but gotta get some $$$$. How does your truck run with the mods you have now?

 

With just the pump tuning done, I could stay right with low to mid 14 second trucks from a roll. My launch would hurt me in the 1/4, I've really toyed around with the idea of a full billet auto, but I have other priorities right now. I'm pretty sure the injectors dropped me down to be able to run 13's in the 1/4, its alot more fuel. Once I get a new turbo and bump my timing, I see low 13's to maybe high 12's if I had an auto and good launch.

 

ya I would love to run a built auto to but it costs alot less to get a manual to hold what im gona have than a auto

 

my 89 f150 with a 5.0 has a Borg warner t18 which can support a 7.3 diesil