I was driving along about 45 and I was in 4th gear and my Allison must have slipped because I was stuck in 4th gear it would not shift up or down its an auto and when I parked and put it in park and when I went to put it in reverse its wouldnt go then about 4 hours later I was able to go through all gears then the check engine light went away only after i heard a small clunk or knock of some sort and then I took it to NAPA and had the code read and it said it was a something about the external shift solenoid. And it just happened again help.

 

Code: P0700
Modules: ECM, TCM
Description: Transmission Control Module (TCM) Requested MIL Illumination

Limp mode??

 

I guess it did go into limp mode. Oh and just so everyone knows the tranny fluid to good.

 

it could be your NSBU(neutral safety back up) switch as well

 

Ok im takin it to a auto shop that specializes in transmissions we'll see.

 

Is your P R N D display the correct gear? That would be right on track with BriteWhiteRam.

 

I have the edge cts monitor and it tells what exact gear its in. I dont know much about trannys so be patient with me.

 

I have the same problem with my truck and it turns out the speed senser is going bad. mine only does it when it is below 50 deg outside and when i put the prograhmer in.

 

Okay, the factory display in the dash. Heres a write up we did on the NSBU switch.

 

Thank you so much TPD looks like even I could figure out how to replace the nsbu. Giving I know nothing about trannys do you think a normal person could do this.

---AutoMerged DoublePost---

Toughtrucks funny you should say that cuz everytime its happened to me its been below heck even 40 degrees. But it did do it once before I got the edge juice w/attitude.