need help with pump in tank conversion on 99
#1
need help with pump in tank conversion on 99
hey yall , my sender went after my 3rd lift pump on the block and i bought a sender/pump in tank thingy do and just got the harness from dodge
does anyone have the instuctions for the conversions (blue wire black stripe)
can i run both pumps at the same time
or can i run fuel through the block mounted lift pump
funds are tight so not able to buy a fancy racing pump
any help would be appreciated
does anyone have the instuctions for the conversions (blue wire black stripe)
can i run both pumps at the same time
or can i run fuel through the block mounted lift pump
funds are tight so not able to buy a fancy racing pump
any help would be appreciated
#2
Dont waste your time and hard earned money sticking that pump in your tank. The intank pumps do not provide adequate pressure and coolong for your VP-44. Take the works back to the dealer and do this.
If money is tight, get a Vulcan performance big line kit and put a Holly Blue or OEM Carter pump on your framerail and isstall 1/2" lines and eliminate the banjo bolts. if you install this right, you can upgrade to a better lift pump later on when funds permit.
http://www.vulcanperformance.com/Dra...p/vpps9804.htm
If money is tight, get a Vulcan performance big line kit and put a Holly Blue or OEM Carter pump on your framerail and isstall 1/2" lines and eliminate the banjo bolts. if you install this right, you can upgrade to a better lift pump later on when funds permit.
http://www.vulcanperformance.com/Dra...p/vpps9804.htm
Last edited by Dr. Evil; 03-31-2009 at 05:01 PM.
#5
Thread
Thread Starter
Forum
Replies
Last Post
Jet A Fuel
Tech Article Submission
0
06-05-2015 03:28 PM