Hello I have a 01 24 valve automatic with a factory replacement fass pump and mÿ lift pump stopped givin me pressure and I do believe I shut it down in time. I put another fass pump on and I am still not getting any pressure. I am getting power to my plug but my pump will not come on and register pressure. I ran 2 wires from the battery directly to the lift pump piggybacking through the factory harness and still get no pressure from the new LP. I did get a tps code and also replaced that and no luck. Any help would be greatly appreciated!! Thanks

 

You could have a faulty new lift pump.
And have you checked to see If the gauge is still good?

 

That I am going to check today. And for the gauge I'm not sure I just know that I cannot hear the pump kick on. So the gauge is next. The pump is a warranty one so if it is bad I will send it back again. Thanks any other ideas are greatly appreciated.

 

Are you checking for voltage at the pump with it plugged up & attempting to run? Have you checked for voltage on the ground circuit (or you could do a voltage drop)

Sent from my SCH-I605 using Tapatalk 2