02 6.6 help
#1
02 6.6 help
have a 02 6.6 dmax that keeps loosing its prime can use the hand pump to get fuel will start run a min. then die pump it up again and same results. I have dropped the tank twice I founld the lil valve had came off the bottum of the pick up moduel so i snapped it back in but that did not help what else should i check next, runs fine when the filter has fuel plenty of power til it goes dry.
#2
#4
#5
#6
x2
no expert by any means but check out the plastic bleeder screw on top of the fuel filter housing. Mine was doing the same thing a while back and I finally figured out that that screw was cracked and letting air into the system. Couldn't tell it was cracked by looking at it.
question, if you are in the incline state(rear up) will it run for a while no problems...no leaks on incline either?
#7
I had the same issues. Replaced the air bleeder, rebuilt the fuel filter assembly with viton orings, replaced the 3 fuel lines, still had the issue. Tore into it and connecting the CP3 there are some more rubber fuel lines that I replaced and now runs great. Bought a Carter lift pump just need to get filters for the unit and good to go! Hopefully the pump levels out my injector issues, one is looking not so good.
mckinney
mckinney
Thread
Thread Starter
Forum
Replies
Last Post
kkelly
Chevy/GMC Truck and Duramax Turbo Diesel Forum
0
04-19-2015 06:25 AM