LB7 pinched Crank sensor
#1
LB7 pinched Crank sensor
So yesterday I replaced my waterpump and as I was putting it all back on to spec I pinched the wires for my crank sensor. Then taking the timing housing/fan idle pulley back off to undo to the pinched/or cut lines I stripped the bottom right nut with a 14mm 12sided socket. I need to know how to get that nut off or what size is the hex stud is so I can get the proper tool.
#3
Well I decided not to pull the stud. Instead I cut the lines where I pinched the crank sensor, bought an electrical kit and reworded the sensor. She starts right up. Now I found a problem on my crank. The dowl pin that seats ur harmonic ballencer sheared off. So I'm looking for a kit that can extract what's left of the pin and buy a new one. Machine shops aren't an option for me.
#5
#6
Thread
Thread Starter
Forum
Replies
Last Post
Jet A Fuel
6.7 Liter Dodge Cummins 07.5-12
3
08-03-2015 10:45 AM