Chevy/GMC Duramax 01-04 LB7 Discussion of Chevy and GMC Trucks with LB7 Duramax Turbo Diesel Engines

LB7 tear down

Thread Tools
 
Search this Thread
 
  #371  
Old 08-14-2014, 08:40 PM
4x4manonbroke's Avatar
Diesel Bomber
Join Date: Jun 2010
Location: Tacoma
Posts: 3,202
Received 142 Likes on 136 Posts
Default

yeah i would start with trans also ...

then you can start making power #'s ... like then go twins ..
 
  #372  
Old 08-16-2014, 12:39 PM
Walker.B's Avatar
Diesel Enthusiast
Thread Starter
Join Date: Jun 2013
Location: Dadeville AL
Posts: 382
Likes: 0
Received 19 Likes on 19 Posts
Default

I think I'm gonna get some exhaust on it and if this bullydog works I'll just run it on Eco till I save for trans and efi so far my new injectors have 11.4 miles on then
 
  #373  
Old 08-17-2014, 10:21 PM
Walker.B's Avatar
Diesel Enthusiast
Thread Starter
Join Date: Jun 2013
Location: Dadeville AL
Posts: 382
Likes: 0
Received 19 Likes on 19 Posts
Default

well more good luck I have an injector knocking at 102.3 miles and at 2100 rpm it changes tone and has a rattle sound
 
  #374  
Old 08-18-2014, 12:25 AM
2004LB7's Avatar
Diesel Bomber
Join Date: Dec 2010
Location: Fool's Golden State
Posts: 1,190
Likes: 0
Received 113 Likes on 109 Posts
Default

Well the pilot injection shuts off at 2300 rpm. you will normally experience more rattle at higher mm3 because of this. Many mistake this for injector rattle. This is in fact called pilot rattle. Is it possible that this is what you are hearing?
 
  #375  
Old 08-18-2014, 08:16 AM
Walker.B's Avatar
Diesel Enthusiast
Thread Starter
Join Date: Jun 2013
Location: Dadeville AL
Posts: 382
Likes: 0
Received 19 Likes on 19 Posts
Default

that makes sense and when it's idling it's like a tap tap tap at there drivers side rear of the engine you can here it at the back of the front tire best it's not loud at all and not a hard knock. maybe I just got some bad fuel or I might just be paranoid after working on it so long
 

Last edited by Walker.B; 08-18-2014 at 08:32 AM.
  #376  
Old 08-18-2014, 10:39 AM
2004LB7's Avatar
Diesel Bomber
Join Date: Dec 2010
Location: Fool's Golden State
Posts: 1,190
Likes: 0
Received 113 Likes on 109 Posts
Default

it shouldn't be tapping at idle so that is not pilot knock. try running a little 2 stroke for a few tanks to see if it clears up. are you able to see balance rates?
 
  #377  
Old 08-18-2014, 11:27 AM
Walker.B's Avatar
Diesel Enthusiast
Thread Starter
Join Date: Jun 2013
Location: Dadeville AL
Posts: 382
Likes: 0
Received 19 Likes on 19 Posts
Default

it did it last night on my way home from my girlfriends house about a 22 mile ride only heared it when stopped at a red light it didn't do it today going to work and I can't see balance rates but I'm going to the dealer tomorrow to get the money back you think I should try to get the to check them while I'm there? I really hope it's nothing I don't want to tear this thing down again -__-
 
  #378  
Old 08-18-2014, 05:18 PM
Walker.B's Avatar
Diesel Enthusiast
Thread Starter
Join Date: Jun 2013
Location: Dadeville AL
Posts: 382
Likes: 0
Received 19 Likes on 19 Posts
Default

update I stopped on my way home and put $40 In it and Lucas fuel additive I didn't have any two stoke in the truck and on the 10 mile ride home about 3 miles in it started getting less noticeable and when I got home it was gone completely
 
  #379  
Old 08-18-2014, 11:15 PM
4x4manonbroke's Avatar
Diesel Bomber
Join Date: Jun 2010
Location: Tacoma
Posts: 3,202
Received 142 Likes on 136 Posts
Default

I too started running 2 stoke oil in my 12v and noticed a difference nearly immediatly
 
  #380  
Old 08-19-2014, 12:58 PM
2004LB7's Avatar
Diesel Bomber
Join Date: Dec 2010
Location: Fool's Golden State
Posts: 1,190
Likes: 0
Received 113 Likes on 109 Posts
Default

i would drive it till i dont run then put new injectors in it and do it all over again

of course i would do the regular maintenance and such. wouldn't hurt to run some 2 stroke too.

what about running a tank of bio diesel? that stuff seems to be quite good at lubrication and cleaning things out
 


Quick Reply: LB7 tear down



All times are GMT -5. The time now is 04:18 AM.