6.2l diesel question
#1
6.2l diesel question
do u have to pull the upper intake off to get the fuel lines undone
i want to change the valve cover gaskets they leak pretty bad it looks like and would like to take care of this while the tranny is bein rebuilt
so if u guys know any tricks to doing this let me know thanks in advance
i want to change the valve cover gaskets they leak pretty bad it looks like and would like to take care of this while the tranny is bein rebuilt
so if u guys know any tricks to doing this let me know thanks in advance
#2
#3
ok guess this wil be an undertaking in itelf while the trans is getting done
---AutoMerged DoublePost---
need help can u take thing out that goes where the distributor would without messing ne thing up and does it have to go back in in its exact position?
---AutoMerged DoublePost---
need help can u take thing out that goes where the distributor would without messing ne thing up and does it have to go back in in its exact position?
Last edited by 92typhoon937; 10-13-2010 at 06:39 PM. Reason: Automerged Doublepost
#4
#5
I have always pulled the intake to remove the injector lines. I suppose it could be done without removing the intake. I think it would be a pain though. The problem probably wouldn't be getting them off, but probably getting them back on and torqued.
Last edited by BULLFROG1; 10-13-2010 at 10:10 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Jet A Fuel
6.7 Liter Dodge Cummins 07.5-12
3
08-03-2015 10:45 AM
Diesel Bombers
General Diesel Related
0
05-06-2015 03:20 PM
Diesel Bombers
General Diesel Related
0
03-18-2015 07:30 PM