Well from what i can figure based off other posts, that my pmd is going bad. Intermittent die'n, no trouble codes. Let it sit for a bit to cool then starts fine, sometimes dies again , sometimes not. Question, what brand pmd do yall recommend?? Relocate it? And i saw a post about changing the resister out. Said they range from 1-9. Number one being the "leaner" and 9 being the "richer". Most of my use the number 1 would be the best choice. What brand resister do yall recommend?? Thanks for the help

 

this gets you everything you need to relocate for about the cheapest. this guy is also very good about customer service because ive talked to him on other fourms when i was thinking of buying his product

Dtech PMD

 

I have the same problem: Im relocate PMD with resistor # 9 under front bumper, but
Engine rum perfect, Just in heavy traffic engine stall, and Temperature is 180F,-
when I put my finger over PMD is over heat like 250 F

Please help me
Thnak you
Lou

 

is it on a heatsink?

 

YES IS MOUNTED A HEAT SINK
Thnaks

 

are you sure you installed the resistor right because if it is getting too much electricity it going to get too hot. also did you make your own extension harness

 

NO, I get from internet, PMD, Resistor #9 and extension harnes with 7 years warranty
now, engine is in good condition and temp max. 180F wheen stall PMD id 250F

please try help me
Thnak you very much
Lou

 

I check Resistor, is installed right, Im call to company supply.

Truck is on the same problems

Thank you
Lou

 

ask for a new one it might be deffective.

 

Thanks for you help. Co. supply send a different format PMD-HD and biger Heat Sink
with Resistor # 9. NOW MY TRUCK RUN THE BEST.
Im like de the new PMD L-4.2" W- 3.5" H 1.2" Co. said is new style Heavy Dutty
My truck increase power, Star immediately, no smoke, PERFECT.

Woody 35 Thank you very much por your help
Im very happy
Lou: