6.2 fuel problems
#1
#2
Join Date: Oct 2012
Location: Scugog Island ONT.
Posts: 1,848
Likes: 0
Received 103 Likes
on
103 Posts
Check the last ditch screen on the fuel heater mast inside the fuel manager.
stanadyne part #29244.
Also check the IP fuel inlet-it has screens that can become plugged.
Are you sure that you connected the lines properly when you made the swap?
The water drain line goes to the filter manager side line while the IP line comes out the front.
If you replaced the IP feed line you may need to use a longer line with a loop in it to prevent any kinks,the stock line is molded for that reason.
stanadyne part #29244.
Also check the IP fuel inlet-it has screens that can become plugged.
Are you sure that you connected the lines properly when you made the swap?
The water drain line goes to the filter manager side line while the IP line comes out the front.
If you replaced the IP feed line you may need to use a longer line with a loop in it to prevent any kinks,the stock line is molded for that reason.
#4
Join Date: Oct 2012
Location: Scugog Island ONT.
Posts: 1,848
Likes: 0
Received 103 Likes
on
103 Posts
You said you transplanted a 6.2 short block in place of a 94 6.5 so I expect it has 6.5 accessories.
If that is not the case then the last ditch screen should not be a factor.
---AutoMerged DoublePost---
Do you have fuel at the IP inlet and not from the injector lines?
Also do you have the 6.2 mechanical IP or the electronic 6.5 IP?
If that is not the case then the last ditch screen should not be a factor.
---AutoMerged DoublePost---
Do you have fuel at the IP inlet and not from the injector lines?
Also do you have the 6.2 mechanical IP or the electronic 6.5 IP?
Last edited by racer55; 11-12-2012 at 01:02 PM. Reason: Automerged Doublepost
#7
thank you i will look on Wednesday and get back. i think its the screens bc after awhile of bleeding and cranking i got some fuel out the ip (1991 6.2 ip) and i closed the lines and is started and ran for 10 seconds. then died and now no fuel at the ip. also the 6.2 engine sat for 3-4 yrs before i pulled it out to put in my truck