Wiring up a prank
#1
Wiring up a prank
SO Im sure you guys may have heard the prank where you rig up the brakes to the horn,that way every time they push the brake the horn goes off.
Any tips on doing this?
Also I have heard you can hook it up to the turn signal
I want to try it out but have no clue on where to start.
Thanks for the help!
Any tips on doing this?
Also I have heard you can hook it up to the turn signal
I want to try it out but have no clue on where to start.
Thanks for the help!
Last edited by DuramaxDiesel02; 08-27-2010 at 02:43 AM.
#2
#4
#5
Unplug the hot wire from the horn, take a piece of wire with a spade connector on it plug it on the horn. Run your wire back to the firewall and find a grommet where you can stick it through. Under dash with a test light dont probe any wires check at connector and figure out wich wire on brake pedal switch gets hot when you depress brake pedal. Unplug connector and stick your stripped wire in the right spot, plug it back in and you're done with no spliced wires. If your buddy dosn't have a good sense of humor and can kick your ****, you might wan't to think twice.
#7
#9
#10