Can you do etching yet? I was thinking of getting Ford put on the top of the piston shape and with the oval on it. Maybe the same but with the dodge ram emblem etched in.

 

Unfortunaly no etching yet.. I have looked into several different machines and I just cannot justify the cost. And I have not found a good engraving shop close enough that wants to get into that.. I am still looking though..

 

Do you have any weighted aluminum shift *****? Some more pics would be great.

 

What weight were you looking for?

As far as the pics, I make per order so I don't have any to take pics of at this time.

 

I am interested but I have a 97 250 with the spline not thread got any ideas of what you cab do?

 

I can bore a hole the diameter of the outside of the spline and then run a set screw through the side..

 

I have never owed a weighted shift ****.... I dont know what wieght is good.. 1-2 lbs??

 

The Alumininum ones are pretty light... 0.63lbs.. other materials would be heavier. My brass **** is about 2.5lbs and it is quite heavy.. Have to watch sometimes when in 3rd or 5th that you don't hit bumps too hard. Although the ones I have pictured in the beginning of the thread are smaller in diameter. I could make them a little bigger out of aluminum and maybe get them up to 1 lb.. just let me know what you want..

 

I don't know. if you got my email and I haven't hit 10 post yet so here my email so I can send a design I have astrong63b@gmail.com

 

I would love the etched cummins but since you cant do that anymore then I guess something like looked like a cummins piston but necks down/ tapered to the shifting rod.