Check Engine Light
Since I installed the TS Programmer, my check engine light comes on when I mash the pedal, then it will go off after a few minutes...
Can anyone help me understand what is going on? The TS Programmer is Off-the-Shelf Tunes and I don't have aftermarket injectors.
Can anyone help me understand what is going on? The TS Programmer is Off-the-Shelf Tunes and I don't have aftermarket injectors.
More then likely its an overboost code or a ICP pressure code...
Do you have gauges?
Edit...
Watch your boost gauge, if you see over 22psi then the truck will defuel and set a SES light...
Does it do it in the lower settings or only in the higher settings?
Do you have gauges?
Edit...
Watch your boost gauge, if you see over 22psi then the truck will defuel and set a SES light...
Does it do it in the lower settings or only in the higher settings?
Yes, I have gauges and it does show going over 22 psi...
Is this something I should address and fix? If it's trying to defuel then it's losing power, right?
I've been trying to come by and see what you think is going on...Shi-ite keeps getting in the way. Thank you for the info.
Have you moved yet?
---AutoMerged DoublePost---
A boost fooler? Can you explain what that is and what it does?
Have you moved yet?
---AutoMerged DoublePost---
A boost fooler? Can you explain what that is and what it does?
Last edited by dbranson1; May 5, 2011 at 10:22 AM. Reason: Automerged Doublepost
Overboost Annihilator
Right there is the fix for your issue... I have installed 15 or more over the years.
Clay at RiffRaff has one as well...
http://www.riffraffdiesel.com/mm5/me...Category_Code=
Right there is the fix for your issue... I have installed 15 or more over the years.
Clay at RiffRaff has one as well...
http://www.riffraffdiesel.com/mm5/me...Category_Code=
Joe posted the link, basically it's a regulator that prevents the map sensor from seeing boost over a set amount therefore not setting the check engine light and defueling the motor.



