TS Performance 6 position Chip
#1
#2
Super easy...
http://www.totaldieselperformance.co...stall94-97.pdf
just make sure you get the silicone off but don't try to kill the contacts... I use my fingernail first to get the silicone off, then once I think it's all gone, give it a few scrubs with the scotchbrite... Too much cleaning is worse than not enough because it's a difficult process to go back on...
Also, leave your keys in your pocket and disconnect the batteries...
http://www.totaldieselperformance.co...stall94-97.pdf
just make sure you get the silicone off but don't try to kill the contacts... I use my fingernail first to get the silicone off, then once I think it's all gone, give it a few scrubs with the scotchbrite... Too much cleaning is worse than not enough because it's a difficult process to go back on...
Also, leave your keys in your pocket and disconnect the batteries...
#3
Thanks, I have the box out now and cleaned the terminals. The directions on their website were wrong so I did more work than was necessary to remove the box. The directions you sent were dead on, but I was done removing it by the time I checked for a response. Oh well.
Sent from my DROID X2 using Tapatalk 2
---AutoMerged DoublePost---
YAY!
Chip installed, truck reassembled, everything works on all 6 settings, will be taking the truck out for a test drive shortly. Will report on my MPG increase after I get back from Texas in a week; leaving tomorrow for Texas and taking the truck.
Sent from my DROID X2 using Tapatalk 2
---AutoMerged DoublePost---
YAY!
Chip installed, truck reassembled, everything works on all 6 settings, will be taking the truck out for a test drive shortly. Will report on my MPG increase after I get back from Texas in a week; leaving tomorrow for Texas and taking the truck.
Last edited by MatieA; 05-11-2012 at 10:10 AM. Reason: Automerged Doublepost
#7
#9