2012 Excursion Conversion
#1
#3
#5
Started on the Excursion today. Drilled out the floor and outer rockers, Need to cut the inner rockers and the windshield pillars and the front part body will be lose. Pulled the rear drive shaft so all we have to do is cut the frame and roll the body, frame and motor and tranny of the frame rack. The 2nd row seats from the Expedition EL showed up today.
#6
Got the front end off the Ex today.
---AutoMerged DoublePost---
Got the rest of the body off today and the tank drained, gas, brake lines, electrical wires removed. Also have the rear axles all unbolted and ready to roll of the rack.
---AutoMerged DoublePost---
Got the rest of the body off today and the tank drained, gas, brake lines, electrical wires removed. Also have the rear axles all unbolted and ready to roll of the rack.
Last edited by NorthCentral Customs; 01-31-2014 at 10:19 PM. Reason: Automerged Doublepost
#7
Got the frame cut on The EX today. Rolled the front half off with the motor and trans still in the frame. Rolled the back axle off and outside to. Put the 2012 on the frame rack and gutted the interior. Monday call for the windshield to be cut out and started taking everything off the underside off the truck.
#9