6.5 cutting out
My buddy has a 6.5 turbo diesel in a 94 3/4 chevy. He cannot go over 55mph. The motor starts bogging down. What could be the problem ? Sensor, module, need help fast.. Thanks for the help.


try ssdieselsupply.com email walt he'll get back to you on it if you have any codes put them in the email its on there tech page had a 1997 6.5 sold it to my friend did a lot to it could run with the stock late models no problem
Last edited by lv2cruzz; Feb 15, 2010 at 08:57 AM.
Yes it runs and idles fine until you get to around 50 - 55 mph then it wont go any faster. Something was mentioned about a throttle position sensor???
---AutoMerged DoublePost---
I read something about replacing the PMD could this be the problem?(pump mounted driver) is that small black box mounted on the side of your injection pump. It is a signal amplifier that powers the fuel solenoid
---AutoMerged DoublePost---
I read something about replacing the PMD could this be the problem?(pump mounted driver) is that small black box mounted on the side of your injection pump. It is a signal amplifier that powers the fuel solenoid
Last edited by lifted7.3; Feb 15, 2010 at 09:36 AM. Reason: Automerged Doublepost
there might be some stored codes too that wont trip the ses light. im thinking its something with the tranny. i wish i had my factory service books but there currently in another state being used by my friend because they would have some good diacnostic things to do.
Thread
Thread Starter
Forum
Replies
Last Post




