Need Tech Help
#1
Need Tech Help
Been browsing Industrial Injections site and have questions before I make any purchases. Am looking to go with 100hp nozzles and wondered if bag o parts will supply enough fuel or should i plan on getting 33% over cp3? Also will be adding lift pump will 95 gph supply that or will I need 150? Plan to use the Thunder 330 turbo. I also found a bottom end girdle and wanted some opinions if that is needed for what i have planed. Thank everyone for your time and appreciate your help and experience.
#3
Anyone else? I take all opinions and input I can get. Thanks. Also wondering if anyone knew where I could find a copy of the book for an edge attitude monitor (the old style not cs or cts)?
Horsepower goals are somewhere between 450-600. Looking for a drivable truck, power to pull gooseneck when I need and still be able to take it to pull at local fairs, maybe not every event but some. Fuel economy is a factor but as long as I get 13-15 or better I dont care. Figuring it by hand I get 22.5 on long highway trips no load and 17.2 when around town with some heavy foot. I am not looking for a smokin rig I prefer to keep the edge, I like its simplicity and ability to turn up and down as needed. Been talking with Goerend for trans and will be installed before any fueling upgrades.
Horsepower goals are somewhere between 450-600. Looking for a drivable truck, power to pull gooseneck when I need and still be able to take it to pull at local fairs, maybe not every event but some. Fuel economy is a factor but as long as I get 13-15 or better I dont care. Figuring it by hand I get 22.5 on long highway trips no load and 17.2 when around town with some heavy foot. I am not looking for a smokin rig I prefer to keep the edge, I like its simplicity and ability to turn up and down as needed. Been talking with Goerend for trans and will be installed before any fueling upgrades.
#4
Dangerous pretty much hit it on the head. For CP-3, do it right and get the whole pump. As far as your EDGE, I don't remember getting a book with it. But I also bought mine as a refurb'd unit. Any Q's just ask. And a girdle is a waste for the power that your going to add. Spend it elsewhere.
The following users liked this post:
bullhead (08-04-2011)
#7
#8
Thread
Thread Starter
Forum
Replies
Last Post
Diesel Bombers
General Diesel Related
0
11-28-2014 09:50 PM
Diesel Bombers
General Diesel Related
0
11-12-2014 08:10 AM