My father has a Banks High ram intake that he is willing to give me. It's off his 05' ram 2500 that he just sold.

My question is, can this intake be used on my 99' or not. Banks makes the part for both years, but one is listed as 98' - 02' and the other 03' - 07'.

That leads me to believe that the 05' will not fit my 99'

I hate to have him ship it up from Florida, to find it was a waste of time, not to mention money.

Thanks, Mark


Link to Banks page:
http://store.bankspower.com/Categori...8-9d6aa3adf6ea

 

dont quote me on this but i beleive it will work, i have also been told that they will work on 12v's but im not positive

 

One yes gives me hope. Thanks for the quick response...

 

The mounting flange is the same between 2nd and 3rd gen. But, the angle of the inlet from the intercooler tubes is different.

So, it wont just bolt up and work.

~Wes~

 

but you probably could make it work so if its free go for it and i bet you can make it work

 

I'm going to give it a try. I'll look into another intercooler tube if the angle needs to much elbow grease.

Thanks to all..

 

Do a write up on it so that we can all see how you make it work... And then if anyone else wants to try they have somthig to go by!

 

they are much easier to come by then twin rams so i may try to make one work someday if yours works out decently

 

Intake is supposed to be here by the end of September. That's when Dad plans on a PA visit. I will try to get it to work and do a write up on it.

Thanks for the advice and pointers. Later