s363
#1
s363
Hey yall. so im looking at getting a new charger for my 05. I was looking into getting a
htt s363 with a .91 divided housing. I know I will need a t4 manifold but what else is necessary to fit on of these to my truck. I wouldn't mind even going to a 2nd gen manifold but I was told that a s300 would clamp directly to my down pipe if I use the he 351 elbow. looking for people have done this and know what to expect. let me know what u think
htt s363 with a .91 divided housing. I know I will need a t4 manifold but what else is necessary to fit on of these to my truck. I wouldn't mind even going to a 2nd gen manifold but I was told that a s300 would clamp directly to my down pipe if I use the he 351 elbow. looking for people have done this and know what to expect. let me know what u think
#2
#3
Please forgive my ignorance... But the searching I have done and looking turns up that a hx40 dp might be the same and the marmon. Also the 2nd gen manifold swap would just involve a manifold and a charge air pipe correct. And then move the oil return line.
Sent from my HTC6435LVW using Tapatalk
Sent from my HTC6435LVW using Tapatalk
#4
#5
#6
Thread
Thread Starter
Forum
Replies
Last Post
CGME
12 Valve 2nd Gen Dodge Cummins 94-98
3
03-05-2015 09:30 AM