Airdog 100 + FP Gauge
#1
Airdog 100 + FP Gauge
After searching for the past hour i have not found a post that makes it clear on the best way to install the FP gauge. The seller has offered the banjo bolt with the package but, my banjo bolt at the VP44 was removed with the Airdog install. So my questions are.....
1. What fitting is needed to tie right into the port on the Airdog
2. After reading, the majority opinion is get FP closer to VP44, whats the best setup this way?
I would just like to have this figured out before they come in the mail so i can install asap.
1. What fitting is needed to tie right into the port on the Airdog
2. After reading, the majority opinion is get FP closer to VP44, whats the best setup this way?
I would just like to have this figured out before they come in the mail so i can install asap.
#2
#4
Diesel Bomber
iTrader: (1)
Fitting...This is for 1/2 line.
Tapped 90 degree 08 fuel pressure access fitting
---AutoMerged DoublePost---
This one is for 3/8 line.
Push on 90 Degree 06 JIC fitting tapped
Tapped 90 degree 08 fuel pressure access fitting
---AutoMerged DoublePost---
This one is for 3/8 line.
Push on 90 Degree 06 JIC fitting tapped
Last edited by turbo20psi; 10-03-2011 at 08:44 PM. Reason: Automerged Doublepost
#5
Thread
Thread Starter
Forum
Replies
Last Post
Jet A Fuel
Tech Article Submission
0
06-05-2015 03:55 PM