head job
#1
head job
Head goin back on this week. Got some arp studs. A buddy says to cycle the studs by goin through the torque specs and than loosening em back up n do it several times. Sound ok? I've built aquite a few BBC's and never did this. Just wondering on some thoughts. I know after about 100 miles to do them again bit it sounds a lil off to me . Also goin on is a phatshaft 62 85 HP sticks edge cts pulse manifold fass 150 . What kind of power can I expect?
#2
#4
#5
your local library may have a manual that you can use. but if i remember right the numpers on the bolts are as follows
22 14 6 3 11 19
26 18 10 2 7 15 23
25 17 9 1 8 16 24
21 13 5 4 12 20
if you google (dodge 24v head bolt pattern) in google image search it will pull a diagram that labels all the bolts right. im not able to show the bolt labels well enough on here.
also if i remember right u torque them in sequence to 77ft lb then go back through and torque them to 85 or somthin close. then you go one more time through them and turn them another 90 degrees all in sequence. i just redid mine a few days back. i went through all holes and blew them with air then cleaned the threads on bolts with a brush grinder. hope it helps ya
22 14 6 3 11 19
26 18 10 2 7 15 23
25 17 9 1 8 16 24
21 13 5 4 12 20
if you google (dodge 24v head bolt pattern) in google image search it will pull a diagram that labels all the bolts right. im not able to show the bolt labels well enough on here.
also if i remember right u torque them in sequence to 77ft lb then go back through and torque them to 85 or somthin close. then you go one more time through them and turn them another 90 degrees all in sequence. i just redid mine a few days back. i went through all holes and blew them with air then cleaned the threads on bolts with a brush grinder. hope it helps ya