cost of p pumping a 24 valve?
Diesel Enthusiast
Joined: Jan 2009
Posts: 369
Likes: 27
From: SARASOTA, FL
just finished mine, with a 175 pump all the front plate gears, throttle, ddp dvs, 4k gsk, lines, and a Diesel Pro cam... mine was $2575. SUPER CHEAP for all that stuff. my lines are .093 mild steel. i got most my lines from Aden at GOS Performance 
if your lookin to do it, find the parts off a scrapped 12v. i got my parts plus pump for like $1100 so there ya go
if your lookin to do it, find the parts off a scrapped 12v. i got my parts plus pump for like $1100 so there ya go
Diesel Enthusiast
Joined: Feb 2010
Posts: 200
Likes: 9
From: spokane
just finished mine, with a 175 pump all the front plate gears, throttle, ddp dvs, 4k gsk, lines, and a Diesel Pro cam... mine was $2575. SUPER CHEAP for all that stuff. my lines are .093 mild steel. i got most my lines from Aden at GOS Performance if your lookin to do it, find the parts off a scrapped 12v. i got my parts plus pump for like $1100 so there ya go
if your lookin to do it, find the parts off a scrapped 12v. i got my parts plus pump for like $1100 so there ya go
Diesel Enthusiast
Joined: Jan 2010
Posts: 112
Likes: 7
From: South Texas
check out this months issue of dieselpower mag it has a yellow and black dewalt ford on the cover... they have an article on p-pumpin a 24valvle and how its done and how much it costs... i know haisley machine sells a conversion kit for around $1300 i think and then you gotta get a pump
Once you sell the stuff you pull off it isnt that bad at all. I recommend finding a good pump and all the parts used, this will save alot of $$$. It's hard to put a cost on it because there are so many different things that can come up. I did a cam and a few other things at the same time. As far as being street friendly goes I love mine. I got lucky and did not have a tuning nightmare like some though. I put mine all together set the timing at 24*, pulled the plate out of the pump I had on, moved the AFC FF and it was perfect. I had 17 miles on my swap and got in the truck and drove it to NC 900 and some miles, daily drove it for 2 months, dynoed it, and drove it home with no problems. If anyone is close enough they are welcome to come go for a ride or look it over once it is back together. It's back in the shop for another surgurey right now.
Diesel Bomber
Joined: Nov 2009
Posts: 1,058
Likes: 53
From: Sanford, Colorado
check out this months issue of dieselpower mag it has a yellow and black dewalt ford on the cover... they have an article on p-pumpin a 24valvle and how its done and how much it costs... i know haisley machine sells a conversion kit for around $1300 i think and then you gotta get a pump
