Installing An Edge Comp
#11
are these the wires needed for installation.i just bought this thing and it wont start, then i noticed these wires.
I just can't get it running. I replaced plugs, cps, valve cover gaskets and harnesses plug relay{old and new relay doesnt have any power to the load side while key is on}, new 1000 cold amp batteries. The frame fuel pump didn't work{no power to it while key is on} untill I hot wired it then had good fuel pressure but still won't start. changed the oil, new fuel filter.....turns over fine, just wont start. im dying here.it also has got good pressure at resivor when i hot wired the pump. again, red,yellow,blue, black cut. They are leading to one of the moduleson the fire wall under the engine compartment fuse box.. No WTS light,no code reader power , no fuel pump power, no glow plug relay load side power, all fuses good.. picture on this link.
http://sphotos-b.xx.fbcdn.net/hphoto...14926870_n.jpg
I just can't get it running. I replaced plugs, cps, valve cover gaskets and harnesses plug relay{old and new relay doesnt have any power to the load side while key is on}, new 1000 cold amp batteries. The frame fuel pump didn't work{no power to it while key is on} untill I hot wired it then had good fuel pressure but still won't start. changed the oil, new fuel filter.....turns over fine, just wont start. im dying here.it also has got good pressure at resivor when i hot wired the pump. again, red,yellow,blue, black cut. They are leading to one of the moduleson the fire wall under the engine compartment fuse box.. No WTS light,no code reader power , no fuel pump power, no glow plug relay load side power, all fuses good.. picture on this link.
http://sphotos-b.xx.fbcdn.net/hphoto...14926870_n.jpg
Thread
Thread Starter
Forum
Replies
Last Post
Rusted Dragon
24 Valve 2nd Gen Dodge Cummins 98.5-02
0
02-27-2015 09:46 PM