6.7L VVT turbo on a 24V?
#1
6.7L VVT turbo on a 24V?
I have seen a few discussions about using the turbo from a 6.7 on the older trucks, but I have yet to find a definitive answer to the "does it work" question.
Will it bolt to my stock manifold? Is there a good way to control the servo, or can I just "stick" it in place at 14cm or so...?
Just asking because they seem to pop up fairly regularly, and seem to be cheap too.
Thoughts or suggestions?
Thanks
---AutoMerged DoublePost---
I know that some of you are smart enough to answer this for me... Aren't you?
Will it bolt to my stock manifold? Is there a good way to control the servo, or can I just "stick" it in place at 14cm or so...?
Just asking because they seem to pop up fairly regularly, and seem to be cheap too.
Thoughts or suggestions?
Thanks
---AutoMerged DoublePost---
I know that some of you are smart enough to answer this for me... Aren't you?
Last edited by bryson; 07-25-2009 at 07:40 PM. Reason: Automerged Doublepost
#2
That is one of a couple projects that I have going on right now, except we are working on it for a CR. You need an adapter for the flange, and a downpipe. Then we are going to either run a boost reference switch, or find a way to reference the APPS for running the VGT. I haven't really been shopping, thats on my friends end. If you have any links to one, shoot me a pm, I may pick one up to start playing with it on my 24v. It could be sweet. I love that turbo on my 09.
Sean
Sean
Thread
Thread Starter
Forum
Replies
Last Post
avatardvr
Ford Powerstroke 03-07 6.0L
18
08-08-2019 12:38 AM