This is the setup i'm lookin at is there any others out there that offer a similar set up does anybody have this or know anybody that does i want the good, bad, and the ugly everything. Also what all is involved in studding the head is it as simple as pullin the head swappin the gasket and bolts, or is it way more involved than that? As always guys thanks for your input and help.

 

Uhhh, what are you looking at? I don't see anything....

Swapping is studs involves removing one bolt and them replacing that bolt with a stud and torquing. No head removal required.

However, if you are doing o-rings, then yes, the head gets removed, machined adn reinstalled on a new gasket.

Dave