Whats Easier On Airdog Install
#1
#2
Personally I drop the tank when I have to work on these things. I can drop it in less then a half hour from loosing the first first fitting to out from under the truck and put it back in place in less then 45 minutes from the time I start slidin it back under the truck to finished. This of course doesn't include siphon time cause that can vary from minutes to an hour depending on how much fuel you have but it's easy to do. Dropping the tank also gives you the chance to clean it out good.
#3
#4
It depends on what you have in/on your bed. We have dropped multiple tanks at the cave and have yet to pull a bed. I personally think that it is easier to drop the tank, I can have it out in less than 5 minutes, but I have dropped about a dozen tanks on second and third gens in the last two months. If you have a lift and a transmission jack I would drop the tank. If you are doing it on the ground, I would pull the bed.
#6
#7
I always pull the tank just cause I don't have any way of lifting the bed and puttin it back down in what I consider a controlled manner. I'm usually workin by myself on this stuff. All I use to drop the tank is two of the little junk tie down straps. The cheap ones work the best. One under each end of the tank lets you drop it and put it back up the same way by yourself quick and clean.
#8
#9
#10