hey , i just installed my edge comp on my 98.5 cummins. the install went well smoothly. but results werent so impresive.
i held the button and realease to make the leds on the box flash and cranked that up and the regular dial cranked up so 5x5 settting.

i have the stock lift pump still and on 5x5 wot, psi dint go under 11psi. and max boost see was 26.....:S theres gotta be something wrong here, its a stock truck with an hx35/40 turbo. stock injectors too , it smoked but not ALOT.....

got the wire tap on the pump hooked up to ... can some one fill me in ..

got a raptor 150 and 125hp DAP injectors on the way. i shoulda spoooled up more boost then that.... even tho the trucks currently stock with a pprogrammer maxed out..

---AutoMerged DoublePost---

tested the grey wire at the tap , but tested it at the edge box connector and no voltage with key on engine off. wire tape must be garbage,....

 

Sounds like it is not tapped correctly to me.

Need to look into getting a stealth plate cover.

 

Only getting 1 volt at my modual from my wire tap.

 

what is the voltage supposed to be?

 

12v . Figuered put i tapped the wrong wire:p

 

reason I ask, I have a stealth plate on mine , I don't have much coming from my edge comp. gunna check my voltage, make sure its getting the correct voltage.

 

Ohh key on engine off 12 volts at wire tap

 

Thanks I'll check that out.