fp gauge question
#1
fp gauge question
I have a ev2 gauge for my 01 2500
I have searched and am still confused on if i need a banjo bolt, a snubber or both?
Thanks
Sam
---AutoMerged DoublePost---
12MM Banjo Snubber - '98.5-'09 Dodge Turbo Diesel-Geno's Garage
would this be the correct part?
I have searched and am still confused on if i need a banjo bolt, a snubber or both?
Thanks
Sam
---AutoMerged DoublePost---
12MM Banjo Snubber - '98.5-'09 Dodge Turbo Diesel-Geno's Garage
would this be the correct part?
Last edited by sampewsey; 02-12-2013 at 12:33 AM. Reason: Automerged Doublepost
#2
Depends on where your putting the sender, if you locate it right at the vp yes you will need a 12 mm banjo snubber.. Some guys use the banjo bolt with a grease hose to get the sender away from the vibration of the pump, I had a grease line swell shut and cut off all fuel on one of my trucks so I don't use that setup(just my preference).. I did away with all banjo bolts on mine with 3/8 line all the way from the tank used a 3/8 tee with 1/8 npt and connected between the stock filter and the vp
Thread
Thread Starter
Forum
Replies
Last Post
scottxmorris
24 Valve 2nd Gen Dodge Cummins 98.5-02
3
10-08-2014 02:14 PM