hi was wondering what setup i need to get around 400hp pump is turned up what injectors need what motor work needs done

 

What all have you done to your pump? What turbo does yours have there was a couple different turbos on the early 12vs. Have u done the afc yet? Gauges? Studs? Might Want to fill in your signature. Tranny?

 

400 is pretty easy n not that expensive. check my signature, im goin to a dyno in march, but i should be 400+

 

whats the afc i have the pump turned up should i put a bigger clutch in it i was told its like a 450hp clutch valair if i take it to a diesel shop around here will they be able to tell me what all i need to get it up to 400hp how much more am i gona spend to get it to 500hp

 

i would say take the plate out, do the Mack rack plug, tune your afc, 4kgov. spring, do a 4 or 5inch exhaust. as for the clutch if you want to say under $1000 for a clutch you will have to do a single disc. i would do the valair k/c 13'' flywheel that will hold 500hp. set your pump timing to 16-17 degrees. the stock hx35 will get you to 400hp but you will have to push it hard. i would look at and 60/60/16 which is and hx40 or a 3rd gen turbo from and 04.5-07 cummins. injectors i would go with a set of 215 out of a 96-98 12v 5speed or if you have the money do 90hp injector.

this is how you tune your afc
http://www.dieselram.com/showthread.php?t=184064

 

yank plate..... 5x12's.....191dv's..... 4k gsk and 60lb springs.... 62/65/12.... 16*timing.... you should be there

---AutoMerged DoublePost---

O and a GOOD afc tune

 

I would save youre pennys and go double disc on the clutch-i wish i did