power???
#11
#12
#13
the 60lbs springs are a project to do, you would need a tool to compress the springs so you can take off the clips and put the new springs on, you also have to make sure the cylinder you do is at tdc so you dont lose the valve into the cylinder, even with right tools its kinda a pain to get them set up right so they dont slip apart, you would also have to do a valve adjustment when your all done
i think i shop would charge around 6-8 hours of labor to do them, correct me if im wrong, i did them once on a cr but i cant remember how long it took, the springs are the cheap part
i think i shop would charge around 6-8 hours of labor to do them, correct me if im wrong, i did them once on a cr but i cant remember how long it took, the springs are the cheap part
#14
#16
Thread
Thread Starter
Forum
Replies
Last Post
1ATony
1A Auto Parts
1
01-05-2016 12:03 PM
1ATony
1A Auto Parts
1
12-07-2015 01:09 PM
1ATony
1A Auto Parts
1
10-29-2015 02:11 PM
Diesel Bombers
General Diesel Related
1
05-10-2015 10:57 PM