Thx everyone it is a .020 cummins gasket did deck the head and decked the block when it was rebuilt 2000 miles ago should of studded it then. but as soon as i turned it up i blew the gasket but thats were the luv comes in just want to do it right this time i like the setup i got now dont think i will chge it did a mbrp 4in turbo back,3000 gov spring,s&b cold air intake ,a #10cam plate,set timing at 14.5-15 degrees,and just got gauges pryro,boost and fuel pressure,from Diesel Dawg thx Brudda! great deal too! came fast and good customer service! so there seems to be a little difference in torque styles cold vs warm? my buddy has a mill so hes doing the pedstals for free so i will go for that and bottom tap the blck but thx again this site is the best out there much Mahalo's and Aloha Hop Sing

 

Torque cold.

 

did you do them with a grinder or just a flat file? i would love to see some pics of this

and yes i know bout the thinner coppers but most people dont know, or dont think about them

 

crap I knew something looked different on #6

did them on a mill, pic is below

 

The hardest part about modding them is getting them set up in the mill.

Ah but a picture is worth a thousand words.