can anybody tell me what i have to do to put these in i cant find an install thread

 

on the side of the pump there is a 7/8 plug next to the throttle lever remove that plug turn the motor clockwise until the spring coms to the top mark where the nut is and how many turns down to make sure you get it back in the same place remove the nut use a magnet to gather the parts and shims ect leave the largest spring but remove all the rest springs use the springs supplied in the kit with the other large spring and put back together then turn the motor over until other spring shows up hope this helps you

 

thank you so much it doesnt seem to be to hard but i guess we will find out

any clues on why i have no overdrive?

 

check your fuses and relays whats the color of the fluid any change when you push the od button will the conveter lock up

 

i checked the fuses and relays and i just put more fluid in it a week or so ago and yes when you put overdrive off it will lock up

my truck will only do 70mph at wot

 

was the fluid burnt brown how low was it

 

it was empty and i have to check it again to see the color

 

it sounds like you od unit is burned up

 

how do i change it or fix it and what kind of money am i looking at?